Weatherstrip 5509

Weatherstrip 5508

Weatherstrip 5510

Estimates depending on the material and its hardness.

E-shaped weatherstrip for high temperatures, for door of revolving oven, in silicone material.

4 Comments

JUAN PABLO says:

13 February, 2017 at 10:37

GOOD DAY I AM PABLO DE LABORATORUO NESETIRAIA SAVER IF YOU HAVE SOME DISTRIBUTOR SONA NORTE TO BE ABLE TO CONNECT Weatherstrip 5509 FROM THERE THANK YOU VERY MUCH

Reply
- Rosario Burletes says:
  
  14 February, 2017 at 11:27
  
  Hello Juan Pablo, from the sales area they already contacted you directly to your email.
  Regards!
  
  Reply
Juan Carlos Lezcano says:

4 June, 2022 at 17:46

necesitaria burlete 5509.para puerta de horno rotativo 3mts gracias

Reply
- Rosario Burletes says:
  
  20 January, 2023 at 10:37
  
  Hola Juan Carlos, ya derivamos tu consulta para que un asesor técnico se comunique con vos vía email.
  Gracias!
  
  Reply

Leave a Reply Cancel reply

RUBBER / METAL ADHESION

The factor that most influences the ease of adhesion is the type of rubber base and its formulation.
Preparation of the metal:
Cleaning:
Chemistry: Use solvent (eg ethyl, methyl, ketone). Degreaser
Mechanics: Sanding, grinding: Elimination of rust and dry dirt.
Surface Preparation:
Sandblasting: Greater specific adhesion surface.
Final cleaning: Clean again.

RUBBER / RUBBER ADHESION

Preparation of surfaces
Use solvent to clean surfaces
Let evaporate
If joining ends, cut at 45 °.
Recommended adhesives:
To join rubber / silicone:
Selladores »Siloc», »Orbasil», etc.
To join other rubbers:
Pegadores instantáneos: »Loctite», »Ciano»,Cemento de contacto: 3M, etc.
Note: If these procedures are not performed or are not done properly, adhesion may fail. In all cases let dry / cure 24 hours.

ADHESIVE A SUBSTRATE

Steps to follow:
1- Clean the substrate and the type of rubber to be used with liquid that does not deposit fatty residues such as, for example, isopropyl alcohol, trichlorethylene, methyl ethyl ketone, among others.
2- Sand the material and clean it again to remove the impurities.
3- Distribute the adhesive evenly on the 2 surfaces to be glued, in the case of contact adhesive
4- Allow a few minutes to breathe and then proceed to the paste in the case of the contact adhesive.

Click to see the extended tables: