Burlete 30883

Weatherstrip 30660

13 August, 2019

Burlete 31177

13 August, 2019

Burlete para Carrocería en material de Epdm. Se utiliza para los parabrisas del colectivo.

2 Comments

Juan Fernando Etcheverrito Lucu says:

2 November, 2023 at 22:14

Buenas noches,tienen burletes perforados para Ford F100 Año 1955 de parabrisas y luneta trasera.?U gomas para ventiletes y puertas?Favor contestar a mi correo y precio si tuvieran o las hacen a pedido con medidas originales?Favor contestar.mi correo: jfetcheverritoseguros@hotmail.com

Reply
- Rosario Burletes says:
  
  7 November, 2023 at 13:49
  
  Hola Juan, solo trabajamos a pedido para industrias que piden en cantidad. Gracias por escribirnos igualmente.
  
  Reply

Leave a Reply Cancel reply

RUBBER / METAL ADHESION

The factor that most influences the ease of adhesion is the type of rubber base and its formulation.
Preparation of the metal:
Cleaning:
Chemistry: Use solvent (eg ethyl, methyl, ketone). Degreaser
Mechanics: Sanding, grinding: Elimination of rust and dry dirt.
Surface Preparation:
Sandblasting: Greater specific adhesion surface.
Final cleaning: Clean again.

RUBBER / RUBBER ADHESION

Preparation of surfaces
Use solvent to clean surfaces
Let evaporate
If joining ends, cut at 45 °.
Recommended adhesives:
To join rubber / silicone:
Selladores »Siloc», »Orbasil», etc.
To join other rubbers:
Pegadores instantáneos: »Loctite», »Ciano»,Cemento de contacto: 3M, etc.
Note: If these procedures are not performed or are not done properly, adhesion may fail. In all cases let dry / cure 24 hours.

ADHESIVE A SUBSTRATE

Steps to follow:
1- Clean the substrate and the type of rubber to be used with liquid that does not deposit fatty residues such as, for example, isopropyl alcohol, trichlorethylene, methyl ethyl ketone, among others.
2- Sand the material and clean it again to remove the impurities.
3- Distribute the adhesive evenly on the 2 surfaces to be glued, in the case of contact adhesive
4- Allow a few minutes to breathe and then proceed to the paste in the case of the contact adhesive.

Click to see the extended tables: